Take you through fiberglass grating and interlocking garage floor

In order to improve the experience of car lovers, many car service industries have re-laid gratings on the previous cement floors for daily cleaning and overall improvement. 

Divided into two kinds of fiberglass grating and interlocking garage floor

Fiberglass grating. Most of them are whole sheets, of course, some special areas need to be calculated separately. 

When the laying plan is formulated, a drainage ditch shall be excavated on the site so that the waste water will flow into the pond through the drainage ditch. 

When excavating the drainage ditch, the bearing conditions and ground conditions of the FRP grille should also be considered. 

When these conditions are properly addressed, the tissue will be artificially laid. Be sure to pay attention to the construction on the ground.

because many shops now have floor heating, such as fiberglass gratings that need to be ditched, you must know the location of the heating pipes at the beginning of the operation, and do not cut them.

interlocking garage floor. Compared to traditional grilles, people may not know much about this grille, but this grille is much simpler to lay. 

the garage flooring just need to be spliced together. 

Before construction, it is necessary to calculate the area of the site, as well as the actual situation of the environment, special parts on the ground, etc. 

After the plan is completed, it can be laid directly. Thicknesses are 3 cm, 5 cm and 6 cm. 

Either way, there are support points below. It also directs waste water stains out of the grill and into the sink. 

In laying, there is no need for too much manual operation. 

Since the splicing is very simple, if the laying area is not too large, one person can complete it, especially the transportation is also very convenient.